Quantitative agreement between dynamical rocking curves in ultrafast electron diffraction for x-ray lasers.

Electron diffraction through a thin patterned silicon membrane can be used to create complex spatial modulations in electron distributions. By precisely varying parameters such as crystallographic orientation and wafer thickness, the intensity of reflections in the diffraction plane can be controlled and by placing an aperture to block all but one spot, we can form an image with different parts of the patterned membrane, as is done for bright-field imaging in microscopy. The patterned electron beams can then be used to control phase and amplitude of subsequent x-ray emission, enabling novel coherent x-ray methods. The electrons themselves can also be used for femtosecond time resolved diffraction and microscopy. As a first step toward patterned beams, we demonstrate experimentally and through simulation the ability to accurately predict and control diffraction spot intensities. We simulate MeV transmission electron diffraction patterns using the multislice method for various crystallographic orientations of a single crystal Si(001) membrane near beam normal. The resulting intensity maps of the Bragg reflections are compared to experimental results obtained at the Accelerator Structure Test Area Ultrafast Electron Diffraction (ASTA UED) facility at SLAC. Furthermore, the fraction of inelastic and elastic scattering of the initial charge is estimated along with the absorption of the membrane to determine the contrast that would be seen in a patterned version of the Si(001) membrane.

Femtosecond Compression Dynamics and Timing Jitter Suppression in a THz-driven Electron Bunch Compressor.

We present the first demonstration of THz driven bunch compression and timing stabilization of a relativistic electron beam. Quasi-single-cycle strong field THz radiation is used in a shorted parallel-plate structure to compress a few-fC beam with 2.5 MeV kinetic energy by a factor of 2.7, producing a 39 fs rms bunch length and a reduction in timing jitter by more than a factor of 2 to 31 fs rms. This THz driven technique offers a significant improvement to beam performance for applications like ultrafast electron diffraction, providing a critical step towards unprecedented timing resolution in ultrafast sciences, and other accelerator applications using femtosecond-scale electron beams.

A high-power, high-repetition-rate THz source for pump-probe experiments at Linac Coherent Light Source II.

Experiments using a THz pump and an X-ray probe at an X-ray free-electron laser (XFEL) facility like the Linac Coherent Light Source II (LCLS II) require frequency-tunable (3 to 20 THz), narrow bandwidth (∼10%), carrier-envelope-phase-stable THz pulses that produce high fields (>1 MV cm-1) at the repetition rate of the X-rays and are well synchronized with them. In this paper, a two-bunch scheme to generate THz radiation at LCLS II is studied: the first bunch produces THz radiation in an electromagnet wiggler immediately following the LCLS II undulator that produces X-rays from the second bunch. The initial time delay between the two bunches is optimized to compensate for the path difference in THz transport. The two-bunch beam dynamics, the THz wiggler and radiation are described, as well as the transport system bringing the THz pulses from the wiggler to the experimental hall.

IDH-mutant glioma specific association of rs55705857 located at 8q24.21 involves MYC deregulation.

The single nucleotide polymorphism rs55705857, located in a non-coding but evolutionarily conserved region at 8q24.21, is strongly associated with IDH-mutant glioma development and was suggested to be a causal variant. However, the molecular mechanism underlying this association has remained unknown. With a case control study in 285 gliomas, 316 healthy controls, 380 systemic cancers, 31 other CNS-tumors, and 120 IDH-mutant cartilaginous tumors, we identified that the association was specific to IDH-mutant gliomas. Odds-ratios were 9.25 (5.17-16.52; 95% CI) for IDH-mutated gliomas and 12.85 (5.94-27.83; 95% CI) for IDH-mutated, 1p/19q co-deleted gliomas. Decreasing strength with increasing anaplasia implied a modulatory effect. No somatic mutations were noted at this locus in 114 blood-tumor pairs, nor was there a copy number difference between risk-allele and only-ancestral allele carriers. CCDC26 RNA-expression was rare and not different between the two groups. There were only minor subtype-specific differences in common glioma driver genes. RNA sequencing and LC-MS/MS comparisons pointed to significantly altered MYC-signaling. Baseline enhancer activity of the conserved region specifically on the MYC promoter and its further positive modulation by the SNP risk-allele was shown in vitro. Our findings implicate MYC deregulation as the underlying cause of the observed association.

AXSIS: Exploring the frontiers in attosecond X-ray science, imaging and spectroscopy.

X-ray crystallography is one of the main methods to determine atomic-resolution 3D images of the whole spectrum of molecules ranging from small inorganic clusters to large protein complexes consisting of hundred-thousands of atoms that constitute the macromolecular machinery of life. Life is not static, and unravelling the structure and dynamics of the most important reactions in chemistry and biology is essential to uncover their mechanism. Many of these reactions, including photosynthesis which drives our biosphere, are light induced and occur on ultrafast timescales. These have been studied with high time resolution primarily by optical spectroscopy, enabled by ultrafast laser technology, but they reduce the vast complexity of the process to a few reaction coordinates. In the AXSIS project at CFEL in Hamburg, funded by the European Research Council, we develop the new method of attosecond serial X-ray crystallography and spectroscopy, to give a full description of ultrafast processes atomically resolved in real space and on the electronic energy landscape, from co-measurement of X-ray and optical spectra, and X-ray diffraction. This technique will revolutionize our understanding of structure and function at the atomic and molecular level and thereby unravel fundamental processes in chemistry and biology like energy conversion processes. For that purpose, we develop a compact, fully coherent, THz-driven atto-second X-ray source based on coherent inverse Compton scattering off a free-electron crystal, to outrun radiation damage effects due to the necessary high X-ray irradiance required to acquire diffraction signals. This highly synergistic project starts from a completely clean slate rather than conforming to the specifications of a large free-electron laser (FEL) user facility, to optimize the entire instrumentation towards fundamental measurements of the mechanism of light absorption and excitation energy transfer. A multidisciplinary team formed by laser-, accelerator,- X-ray scientists as well as spectroscopists and biochemists optimizes X-ray pulse parameters, in tandem with sample delivery, crystal size, and advanced X-ray detectors. Ultimately, the new capability, attosecond serial X-ray crystallography and spectroscopy, will be applied to one of the most important problems in structural biology, which is to elucidate the dynamics of light reactions, electron transfer and protein structure in photosynthesis.

Photonic-band-gap traveling-wave gyrotron amplifier.

We report the experimental demonstration of a gyrotron traveling-wave-tube amplifier at 250 GHz that uses a photonic band gap (PBG) interaction circuit. The gyrotron amplifier achieved a peak small signal gain of 38 dB and 45 W output power at 247.7 GHz with an instantaneous -3 dB bandwidth of 0.4 GHz. The amplifier can be tuned for operation from 245-256 GHz. The widest instantaneous -3 dB bandwidth of 4.5 GHz centered at 253.25 GHz was observed with a gain of 24 dB. The PBG circuit provides stability from oscillations by supporting the propagation of transverse electric (TE) modes in a narrow range of frequencies, allowing for the confinement of the operating TE03-like mode while rejecting the excitation of oscillations at nearby frequencies. This experiment achieved the highest frequency of operation for a gyrotron amplifier; at present, there are no other amplifiers in this frequency range that are capable of producing either high gain or high output power. This result represents the highest gain observed above 94 GHz and the highest output power achieved above 140 GHz by any conventional-voltage vacuum electron device based amplifier.

Amplification of picosecond pulses in a 140-GHz gyrotron-traveling wave tube.

An experimental study of picosecond pulse amplification in a gyrotron-traveling wave tube (gyro-TWT) has been carried out. The gyro-TWT operates with 30 dB of small signal gain near 140 GHz in the HE06 mode of a confocal waveguide. Picosecond pulses show broadening and transit time delay due to two distinct effects: the frequency dependence of the group velocity near cutoff and gain narrowing by the finite gain bandwidth of 1.2 GHz. Experimental results taken over a wide range of parameters show good agreement with a theoretical model in the small signal gain regime. These results show that in order to limit the pulse broadening effect in gyrotron amplifiers, it is crucial to both choose an operating frequency at least several percent above the cutoff of the waveguide circuit and operate at the center of the gain spectrum with sufficient gain bandwidth.

[Gastrointestinal stromal tumors: our experience]. / Tumori stromali gastrointestinali: nostra esperienza.

The authors report their experience on the treatment of GIST. They point out the importance of classification of the disease in low, medium and high risk neoplasms based on the characteristic of the tumour: site, volume and mytotic index as the Consensus Conference of Bethesda recently established. Surgical procedure remains the most important treatment in localized disease, while patients with advanced disease can benefit from imatinib, a chemotherapeutic agent recently introduced, as an adjuvant therapy.

Bile duct injuries during laparoscopic cholecystectomy: a 1994-2001 audit on 13,718 operations in the area of Rome.

BACKGROUND: Bile duct injuries (BDIs) during laparoscopic cholecystectomy (LC) still are reported with greater frequency than during open cholecystectomy (OC). METHODS: In 1999, a retrospective study evaluating the incidence of BDIs during LC in the area of Rome from 1994 to 1998 (group A) was performed. In addition, a prospective audit was started, ending in December 2001 (group B). RESULTS: In group A, 6,419 LCs were performed (222 were converted to OC; 3.4%). In group B, 7,299 LCs were performed (225 were converted to OC; 3.1%). Seventeen BDIs (0.26%) occurred in group A and 16 (0.22%) in group B. Overall, mortality and major morbidity rates were 12.1% and 30.3%, respectively, without significant differences between the two groups. CONCLUSIONS: The incidence and clinical relevance of BDIs during LC in the area of Rome appeared to be stable over the past 8 years and were not influenced by the use of a prospective audit, as compared with a retrospective survey.

Separation and quantitation of monovalent anionic and cationic species in mainstream cigarette smoke aerosols by high-performance ion chromatography.

A simple method has been developed to separate and quantitate monovalent ionic species in mainstream cigarette smoke aerosols based on ion chromatography (IC) with conductivity detection. The method entails collecting the smoke aerosol particulate phase by electrostatic precipitation, dissolving the smoke condensate in methanol (MeOH), and separating the ionic species on either a cation- or anion-exchange column. The method has been applied to the analysis of smoke aerosols from two cigarettes, 1R4F Kentucky Reference cigarettes and a new cigarette that heats but does not burn tobacco. The predominant cations in smoke aerosols from 1R4F Kentucky Reference and the new cigarettes are sodium (Na+), ammonium (NH4+), and potassium (K+) ions; the predominant anions are acetate (AcO-) and formate (HCOO-). Trace amounts of chloride (Cl-), nitrite (NO2-), and nitrate (NO3-) ions are also present.

Cigarette smoke composition. Part 1. Limitations of FTC method when applied to cigarettes that heat instead of burn tobacco.

The design of a new cigarette that heats rather than burns tobacco calls for modifications to the Federal Trade Commission (FTC) method for analytical smoking. These changes include eliminating sample conditioning at 75 degrees F and 60% RH, exercising greater care in lighting cigarettes, and smoking cigarettes to self-extinguishment rather than to a predetermined butt length as a measure of complete consumption. By several gross analytical measures, smoke condensate from the new cigarette differs substantially from that of tobacco-burning cigarettes. This is inferred from the lack of coloration of smoke condensate collected on Cambridge filters. Elemental analysis demonstrates reduced carbon and nitrogen content concurrent with increased hydrogen. Thermogravimetric analysis shows almost quantitative weight loss at Tmax = 220 degrees C. Ultraviolet (UV) spectrophotometric analysis shows greatly reduced levels of tobacco-derived smoke components and qualitative differences in chemical entities being measured. By design, the heat required for smoke formation is supplied by a carbon heat source embedded in the cigarette tip. Tobacco contained in the cigarette is not burned and is exposed to temperature less than 300 degrees C. Thus, it is apparent (1) that smoke from the new cigarette contains little or no "tar" as tar is classically defined, and (2) that the FTC method even as modified to account for cigarette design differences is appropriate only for determination of nicotine and carbon monoxide yielded from this cigarette.

Separation and quantitation of phenolic compounds in mainstream cigarette smoke by capillary gas chromatography with mass spectrometry in the selected-ion mode.

Cigarette smoke condensate is a complex chemical matrix and determination of phenolic compounds in it frequently requires extensive and laborious sample preparation. By utilizing derivatization techniques and capillary column gas chromatography with mass spectrometry in the selected-ion mode, separation and quantitation of selected phenolic compounds found in mainstream cigarette smoke can be accomplished with minimal sample preparation. This method has been used to determine concentrations of phenol, o-cresol, m-cresol, p-cresol, catechol, resorcinol and hydroquinone in cigarette smoke condensate from a number of commercially available cigarettes and a new cigarette which heats, but does not burn, tobacco. Unlike tobacco-burning cigarettes, levels of the phenolic compounds in the new cigarette smoke are at or below the detection limits for most of the compounds. This result is attributed to the unique design of the new cigarette.